So, your favorite skateboard has broken into two pieces. I know it’s frustrating, but don’t be sad because I’ve got some good news for you! With a little effort, you can fix a broken skateboard. It might not be brand new, but your board will be ready to roll again.
If you are wondering how to fix a broken skateboard deck, this article is only for you! Today, I’m gonna show you three different methods to repair your skateboard with a simple and easy process. Let’s jump into the step-by-step guiding process!
Common Reasons Skateboards Break
Your skateboard goes through a lot, especially if you’re into tricks or heavy riding. Here’s why boards break:
- Bad landings: If you land with one foot on the nose or tail and the other in the center. As a result, the board takes too much pressure.
- Material wear: The wood layers wear down over time.
- Water damage: Wet boards are weaker and more likely to break.
Most boards break in the middle, between the trucks. This spot takes the most pressure when you land. Now, let’s learn how to repair your skateboard.
How to Fix a Broken Skateboard Deck: Step-by-Step Guide!
So, if your skateboard is broken in half, you can always try the following three methods. These are the best ways to repair a broken skateboard. Let’s get started:
1. Quick Fix a Broken Skateboard with Duct Tape
Duct Tape is best for small cracks or temporary repairs. This is the easiest and fastest way to fix a broken skateboard. Here’s how:
- Clean the area: Wipe off any dirt or dust around the crack.
- Align the pieces: Push the broken parts together as tightly as you can.
- Wrap with tape: Use strong duct tape (or carbon-fiber tape if you have it). Wrap it tightly around the damaged area several times.
Related Article: How To Fix Pressure Cracks On A Skateboard!
2. Fix a Broken Skateboard Using Rails
If your deck is cracked but still in one piece. Then Rails is the best option for you. Rails are plastic strips that attach to the bottom of your board. They’re usually for slides, but they can also reinforce cracks. Here is the process:
- Buy skateboard rails: You can find them online or at skate shops.
- Place the rails: Position the rails over the cracked area.
- Screw them in: Use a drill to secure the rails. Tighten the screws to hold the board together.
3. Fix a Broken Skateboard With an Extra Layer of Wood
If your board has wholly snapped in half, you can use wood to make it rideable again. Here are the Steps:
- Cut a wood piece: Measure and cut a rectangular piece of wood slightly larger than the width of your board.
- Glue it: Apply wood glue or epoxy to the bottom of the broken area.
- Clamp it: Use clamps to hold the wood and deck together while the glue dries. Let it dry for 24 hours.
- Drill and screw: Once the glue is dry, drill holes through the board and wood, then secure with screws.
Recently Published Article: How to Replace Skateboard Grip Tape!
Tips to Avoid Skateboard Breakage
- Land properly: Keep your feet over the bolts when landing tricks.
- Avoid water: Don’t skate in the rain or leave your board in damp areas.
- Inspect regularly: Check for cracks or damage and fix them early.
- Store it right: Keep your board in a dry, cool place.
Frequently Asked Questions (FAQs)
How do I fix a cracked skateboard?
To fix a cracked skateboard, start by peeling off the grip tape near the crack. Then, fill the crack with epoxy resin to bond the damaged area. Let it dry for 24 hours to cure fully. Once the epoxy is dry, sand the area smoothly and reapply the new grip tape to complete the repair.
How long will a repaired skateboard last?
It depends on the fix and how you ride. Duct tape fixes are short-term, but wood reinforcement can last longer.
Is it worth fixing a broken skateboard?
If the damage is minor, repairs can save you money. For severe damage, it’s better to replace the deck.
Executive Summary
Fixing a broken skateboard is easier than you think. These methods can save you money and extend your board’s life. Try out these DIY fixes, and don’t forget to inspect your board regularly to avoid major damage. Remember, every repair is temporary, so always skate carefully. Good luck, and happy shredding!
Got any repair tips or questions? Drop them in the comments below!
